1.The dust removal power is very high.According to Baosteel and other users who have used plastic burner dust collectors,under normal circumstances,the exhaust dust concentration can be controlled below 5mg/m3.In high concentration dust removal,the dust removal power reaches 99.999%.

　　2.Long service life.The plastic burner dust collector produced by our company adopts different formulas and different materials,suitable for different working conditions.The plastic burner has acid resistance type,strong alkali resistance type,antistatic type and long service life.

　　3.Good cleaning effect,pressure,equipment resistance.Because the surface of the plastic burnt plate is deeply processed,the air path is uniform and very smooth,which makes the dust very difficult to penetrate and stay,and can maintain a very good dust removal effect.Secondly,the resistance of the equipment is very high,the pressure is lost and the working hours are almost unchanged.Resistance table(lime dust removal)

　　4.The plastic sintered board with strong moisture resistance adopts special formula,which is hydrophobic.Judging from the actual application situation,even in the severe condensation in winter,the imported waterborne dust can be used normally under the condition of full water.

　　5.The space occupied by the small plastic burning board dust collector is only 1/3-1/6 of the bag dust collector,and it can be superimposed to plan and reduce the area.

　　6.It is very convenient for the equipment to change the plastic burning board.It is only necessary to open the dust collector access door and tighten the two bolts that fix the plastic burning board to end a piece of filter board equipment.In daily production,it is almost unnecessary.

　　Assuming that the flame temperature has advantages in preheating wet materials,the temperature of the flue gas entering the cyclone is also high,and water vapor is not easy to cold extract.But when the flame temperature is raised too high,the drying cylinder will be red,even bent,and the activity of slag.This set of ventilation and dust removal uses 10 fans,the exhaust capacity is too large,so there is a phenomenon that the dry medium(hot air flow)is sucked away before the heat is fully transferred to the material.